Kenmore 4602 Use and Care Guide - Page 5

Do@"

©ontsc

The door

chill control

is located

on the left-hand

side of the

refrigerator

compartment.

•

Turn the control clockwise

(right) to reduce the flow of cold air

to the door and make it less cold.

•

Turn the control

counterclockwise

(left) to increase the flow of

cold air to the door and make it colder.

_ and

ce

© s_nse_}s

(on some

mode_s}

Depending

on your model, you may have one or more of the

following

options:

the ability to select either crushed

or cubed

ice, a special

light that turns on when you use the dispenser,

or a

lock option

to avoid unintentional

dispensing.

The Water Dispenser

If you did not flush the water system when the refrigerator

was

first installed,

do so now. Use a sturdy

container

to depress and

hold the water dispenser

lever for 5 seconds,

then release it for

5 seconds.

Repeat until water begins to flow. Once water begins

to flow, continue

depressing

and releasing the dispenser

lever

(5 seconds

on, 5 seconds

off) for an additional

2 minutes. This

will flush air from the filter and water dispensing

system.

Additional

flushing

may be required in some households.

NOTE: As air is cleared from the system,

water may spurt out of

the dispenser.

Allow 24 hours for the refrigerator

to cool down

and chill water.

IMPORTANT:

Depending

on your model, the small removable

tray at the bottom

of the dispenser

is designed

to catch small

spills and allow for easy cleaning.

There is no drain in the tray.

The tray can be removed

from the dispenser

and carried to the

sink to be emptied

or cleaned.

The Ice Dispenser

Ice dispenses

from the ice maker storage

bin in the freezer when

the dispenser

lever is pressed. The dispensing

system will not

operate

when the freezer door

is open. To turn off the ice maker,

see "Ice Maker

and Storage

Bin."

Your ice maker

can produce

both crushed

and cubed

ice. Before

dispensing

ice, select which type of ice you prefer by pressing

the ICE button.

The display

screen

indicates

which type

of ice is selected.

4_ D

crushed

CRUSHED

cubed

CUBED

For crushed

ice, cubes are crushed

before being dispensed.

This

may cause a slight delay when dispensing

crushed

ice. Noise

from the ice crusher is normal, and pieces of ice may vary in size.

When changing

from crushed

to cubed,

a few ounces

of crushed

ice will be dispensed

along with the first cubes.

To Dispense

Ice:

1.

Press the button to select the desired type of ice.

Cut

Hazard

Use a sturdy

glass

when

dispensing

ice.

Failure

to do

so can

result

in cuts.

2.

Press a sturdy

glass against

the ice dispenser

lever. Hold the

glass close to the dispenser

opening

so ice does not fall

outside

of the glass.

To Dispense Water:

1.

Press a sturdy glass against the water dispenser lever.

2.

Remove the glass to stop dispensing.

NOTE: Water may have an off-flavor

if you do not use the

dispenser

periodically.

Dispense

enough water every week to

maintain a fresh supply.

3=

IMPORTANT:

You do not need to apply a lot of pressure

to

the lever in order to activate

the ice dispenser.

Pressing

hard

will not make the ice dispense

faster

or in greater quantities.

Remove

the glass to stop

dispensing.

NOTE: Ice may continue

to dispense

for up to 10 seconds

after removing

the glass from the lever. The dispenser

may

continue

to make noise for a few seconds

after dispensing.

Kenmore 4602 Use and Care Guide - Page 5

©ontsc - model #

Page 5 highlights