Home » Konica Minolta Manuals » Printers » Konica Minolta KIP 75 Series » Manual Viewer

Konica Minolta KIP 75 Series KIP 75 Series Hardware User Manual - Page 47

Paper Jam

View all Konica Minolta KIP 75 Series manuals

Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

3. 1 Paper Jam "xxxx Mis-feed" is displayed in the UI screen when the media is jammed. The jammed location when displaying " xxxx Mis-feed " is shown below. Manual Feeder Section Media Feed Section Fuser Section Roll Deck Section Roll Deck Section NOTE (1) Be careful not to get paper cuts on your hand. (2) Gently remove a jammed paper. When it does not reach Fuser Unit, toner on it may spill off. If toner gets into eyes or your mouth, immediately rinse them with water and contact a doctor. (3) Gently remove a jammed paper. When it does not reach Fuser Unit, toner on it may spill off on your cloth. Dust off your cloth. Use cold water to wash in out. Using hot water may leave a stain. 3-2 Chapter 3 Error Correction

Section	Page
KIP 7570 Series Hardware User Manual A.0	1
Safety	4
WARNING	5
CAUTION	6
POWER CORD INSTRUCTION	7
Chapter 1 Before Use	8
1. 1 Installation Requirements	9
1. 2 Originals Prohibited from Duplication	10
1. 3 Features	11
1. 4 Specifications	12
1. 4. 1 General	12
1. 4. 2 Printer part	13
1. 4. 3 Scanner part (for MFP Model)	15
1. 5 Appearance	16
1. 5. 1 Front view	16
1. 5. 2 Rear view	17
1. 6 Specifications for Scan Original (for MFP Model)	18
1. 6. 1 Original Standards	18
1. 6. 2 Special Documents	18
1. 6. 3 “Do Not Scan” Originals	19
1. 7 Specifications for the Printing Media	22
1. 7. 1 Papers not available to use	22
1. 7. 2 Keeping the paper in the custody	23
1. 7. 3 Treatment against environmental condition	24
Chapter 2 Basic Operation	25
2. 1 Turning on the Printer	26
2. 2 Turning off the Printer	28
2. 3 Replacing Roll Media	29
2. 4 Replacing Toner Cartridge	35
2. 5 Cut Sheet Media	40
2. 6 Copying (for MFP Model)	41
2. 7 Stop of Scan or Copy (for MFP Model)	44
2. 8 Dehumidifying Roll Media	45
Chapter 3 Error Correction	46
3. 1 Paper Jam	47
3. 1. 1 Roll Deck Section Jam (Deck 1, 2 Mis-feed)	48
3. 1. 2 Manual Feeder Section Jam(Registration Mis-feed)	51
3. 1. 3 Media Feed Section Jam(Registration Mis-feed, Separation Mis-feed)	53
3. 1. 4 Fuser Section Jam (Exit Back Mis-feed)	55
3. 1. 5 Stack Jam	59
3. 1. 6 Original Jam (for MFP Model)	61
3. 1. 7 Accessory Jam	62
3. 2 Door Open	63
3. 2. 1 Roll Deck (Deck 1 Open, Deck 2 Open)	63
3. 2. 2 Engine Unit (Front Cover Open)	63
3. 2. 3 Paper Exit Door (Paper Exit Door Open)	64
3. 2. 4 Scanner Unit (Scanner feeder open) (for MFP Model)	64
3. 3 Other Operator Call Error	65
3. 3. 1 Roll Replacement	65
3. 3. 2 Toner Empty	65
3. 3. 3 Accessory Error	65
3. 4 Service Call Errors	66
Chapter 4 Maintenance	67
4. 1 Scanner Unit (for MFP Model)	68
4. 1. 1 Scan Glass, Feed Roller, Guide Plate	68
4. 1. 2 Sensor	71