Konica Minolta KIP 75 Series KIP 75 Series Hardware User Manual - Page 56

Exit Cover., If the print cannot be removed, go to the next step.

Get Konica Minolta KIP 75 Series PDF manuals and user guides View all Konica Minolta KIP 75 Series manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

3. Remove the mis-fed paper. If the mis-fed paper cannot be seen or removed, leave the media and go to the next step. If the paper (including any torn part) can be removed, go to step 8. 4. Hold the gray handles and open the Exit Cover (3). mis-fed media 3 5. Pull and remove the jammed print to the rear. If you remove the print at this time, just close the Exit Cover. If the print cannot be removed, go to the next step. If the print (including any torn part) can be removed, go to step 8. 3 jammed print WARNING Be careful not to get burnt when you touch the printing paper as it may be very hot. NOTE If removed a mis-fed paper inside the Fuser Door, scattered toner can be adhered to the next print. 3-11 Chapter 3 Error Correction

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
Chapter 3
Error Correction
3-11
3.
Remove the mis-fed paper.
If the mis-fed paper cannot be seen or removed,
leave the media and go to the next step.
If the paper (including any torn part) can be
removed, go to step 8.
4.
Hold the gray handles and open the Exit Cover (3).
5.
Pull and remove the jammed print to the rear.
If you remove the print at this time, just close the
Exit Cover.
If the print cannot be removed, go to the next step.
If the print (including any torn part) can be
removed, go to step 8.
3
mis-fed media
3
jammed print
WARNING
Be careful not to get burnt when you touch the printing paper as it may be very hot.
NOTE
If removed a mis-fed paper inside the Fuser Door, scattered toner can be adhered to the
next print.