Konica Minolta Kodak i5850 User Guide - Page 29
Installing the short document adapter, Adjusting the height of the scanner (i5800/i5850 Scanners only)
![]() |
View all Konica Minolta Kodak i5850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Installing the short document adapter The short document adapter can be used when scanning small documents (e.g., checks). This adapter aids in better document stacking. 1. Open the document stop on the output tray as shown in the illustration. 2. Slide the short document adapter over the document stop and push it all the way down. Adjusting the height of the scanner (i5800/i5850 Scanners only) 3. Adjust the sides guides if necessary. The workspace table can be raised approximately 25.4 cm (10 in.) from its lowest position for your comfort when you are sitting or standing at the scanner. When you are raising or lowering the workspace table, be sure that there is nothing close to the scanner that would interfere with the upward and downward movement (e.g., chair, table, etc.). • Press the upper portion of the button on the side of the scanner to raise to workspace table. • Press the lower portion of the button on the side of the scanner to lower the workspace table. If the workspace table will not move up or down from its position, check the following: • Be sure the workspace table is not already in its highest or lowest position. • Be sure the scanner is on and is not in Low Power mode. 3-6 A-61670 August 2014
![](/manual_guide/products/konica-minolta-kodak-i5850-user-guide-1d77f01/29.png)