Kyocera TASKalfa 4012i 3212i/4012i Operation Guide - Page 291

Using Various Functions > Functions NOTE One position staple is not slanted for the following paper sizes. B5-R, 16K-R Mixed Size Stapling Even with mixed paper sizes, if the sizes have the same width as shown in the combinations below, the output can be stapled. • A3 and A4 • B4 and B5 • Ledger and Letter • Ledger and Letter-R • 8K and 16K A4 A3 B5 B4 Letter Ledger NOTE • Number of sheets that can be stapled: up to 30 sheets. • When performing Mixed Size Stapling, refer to the following: Mixed Size Originals (page 6-20) A4 A3 B5 B4 Letter Ledger Letter-R Legal Punch Punches holes in sets of finished documents. Letter-R Legal NOTE • This function requires the optional Document Finisher and Punch Unit. • For details on paper sizes that can be punched, refer to the following: Punch Unit (For 1,000-Sheet/3,000-Sheet Finisher) (page 11-25) • The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole punching. Item Value Description Punch Off 2 holes Left 2 holes Top 2 holes Right Select the position of punch holes. For details on original orientation and position of punch holes, refer to the following: Original Orientation and Punch Hole Position (page 6-27) 3 holes Left 3 holes Top 3 holes Right 4 holes Left 4 holes Top 4 holes Right Original Orientation Top Edge on Top, Top Edge on Left, Auto*1 Select the orientation of the original document top edge to scan correct direction. Select [Original Orientation] to choose orientation of the originals, either [Top Edge on Top] or [Top Edge on Left]. Then select [OK]. *1 This function can only be used when the optional OCR Scan Activation Kit is installed. 6-26