Kyocera TASKalfa 4012i 3212i/4012i Operation Guide - Page 507
Executing Remote Operation from VNC Software
View all Kyocera TASKalfa 4012i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 507 highlights
Troubleshooting > Troubleshooting 5 Start up the browser. Enter "https://" and host name of the machine to access the Command Center RX. Accessing Command Center RX (page 2-61) 6 Select [Device Information/Remote Operation] > [Remote Operation]. 7 Click [Start] button. NOTE • If the user is logged in to the device, the permission confirmation screen will be displayed on the operation panel. Select [Yes]. • If pop-up blocking of the browser occurs during connection of the Remote Operation, select Always allow pop-ups from https:// [host name], and click Done. Perform Remote Operation after waiting 1 minute or more. When the Remote Operation is started up, the operation panel screen will be displayed on the system administrator's or user's PC screen. Executing Remote Operation from VNC Software 1 Display the screen. [System Menu/Counter] key > [System/Network] > [Network] > [Protocol Settings] 2 Set "Enhanced VNC (RFB)" to [On]. Protocol Settings (page 8-53) NOTE • When setting "VNC (RFB) over SSL" to [On], the communication is encrypted. • You can configure the protocol settings using Command Center RX. Command Center RX User Guide 3 Startup the remote operation. 1 Start up the VNC software. 2 Enter the following format separated by a colon to start up the remote operation. "IP address: port number" NOTE When setting "VNC (RFB)" to [On] in step 2, the default port number is 9062. When setting "VNC (RFB) over SSL " to [On], the default port number is 9063. Protocol Settings (page 8-53) 10-24