LG LP070HED1 Service Manual - Page 30
LG LP070HED1 Manual
View all LG LP070HED1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Figure 29 Condensate Tube 11. Place the pump bracket onto the end of the pump by feeding the pump cord through the hole in the bracket and pushing the bracket onto the threads of the pump. Slide the supplied washer onto the threads of the pump. Screw the pump nut onto the threads of the pump and tighten the nut so that the bracket is secure against the pump. (Figure 32) Figure 32 7. Position the condensate tube through existing hole (located right side of blower deck). 8. Make sure the holes in the condensate tube are facing inward toward the blower wheel. 9. Lower the discharge deck over the condensate tube and screw the discharge deck to the chassis with the existing screws. Replace the discharge screen and screw the screen to the discharge deck with the existing screws. 10. Using the overflow tube holder and the overflow tube, hold the tube with the metal holder and screw the holder to the partition panel with the provided 1/2 inch #8 screw. (Figures 30 & 31) 12. Position the pump in the back left corner of the basepan and screw the pump bracket to the basepan with the provided two 1/2 inch #8 screws. (Figure 33) Figure 33 Figure 30 Screws Tube Holder 13. Remove the protective adhesive backing from the plastic Figure 31 U clip and mount the U clip to the plastic condenser shroud in approximately the position shown. (Figure 34) 14. Snap the provided round plastic grommet into the top condenser baffle. (Figure 34) Downloaded from www.Manualslib.com manuals search engine -30-