LG LP070HED1 Service Manual - Page 40

2. To gain access inside the control panel, after removing the knobs and escutcheon, remove the screws holding panel in position. Tilt control panel forward, being careful not to pinch any wires. (Figure 50) 3. As viewed from the front, remove both knockouts on the control panel. 4. Insert two fuse holders from the front. The fuse holders should be oriented so the quick-connect tabs are toward the center of the unit. Attach fuse holders using the screws and nuts provided. (Figure 50) 5. Remove both power cord leads, one lead from the capacitor and one from the electronic board. 6. Install one power cord lead on the center terminal of one fuse holder. (Figure 51) 7. Install the remaining power cord lead on the center terminal of the second fuse holder. (Figure 51) 8. Connect BK-10 wire from the side terminal of one fuse holder to the Line terminal on the electronic board. (Figure 50) 9. Connect RD-10 wire from the side terminal of the other fuse holder to the common (C) terminal on the capacitor. (Figure 51) 10. Tilt control panel back to original location, being careful not to pinch any wires. Align the control panel with the cover and screw panels into place with original screws. Replace escutcheon and control knobs. Fuse Holder Kit Installation (With Subbase) See previous section for installation in the control panel. 1. Remove both knockouts at the fuse holder location. (Figure 52) 2. Install the fuse holders using screws provided. The side connector tab on the fuse holders should be towards the left. 3. Connect a stripped BK-9 wire to the center of the quickconnect tab of the fuse holders. Wire nut the other end of this wire to the black field connection wire (TB1). (Figure 53) 4. Connect the other stripped BK-9 wire to the quick-connect tab on the side of the same fuse holder. Wire nut the other end to black subbase wire leading to receptacle. (Figure 53) Figure 51 - Fuse Holder Diagram Control Panel Installation FUSEHOLDERS WH GN BK Terminal Blocks Behind the Control Panel Transformer Status Light Control Board 5. Connect the stripped RD-9 wire to the center quick-connect tab of the second fuse holder. Wire nut the other end to the red field connection wire (TB3). (Figure 53) 6. Connect the other stripped RD-9 wire to the quick-connect tab on the side of the second fuse holder. Wire nut other end to red subbase wire which leads to receptacle. (Figure 53) 7. Insert time delay fuses into the fuse holders. Size all fuses by the Maximum Overcurrent Protection shown on the nameplate. Also refer to the serial plate on the unit. Figure 52 - Subbase (Left Side) Fuse Holder Knockouts Leveling Leg Power Switch Knockouts Figure 53 - Fuse Holder Diagram Subbase Installation Fuseholder BK-9 Fuseholder RD-9 Electrical Receptacle Downloaded from www.Manualslib.com manuals search engine Field Connection Wiring -40- Green Black Red