LG LP070HED1 Service Manual - Page 8

• ELECTRONIC CONTROLS The controls will look like one of the following. FAN SPEED • Every time you push this button, it cycles through the settings as follows: {High(F2) ¡ Low(F1) ¡ High(F2) ¡ Low(F1)} 'F TEMP E/SAVE HEAT FAN COOL HIGH LOW TIMER MODE FAN TIMER ON OFF POWER • To turn the air conditioner ON, push this button. To turn the air conditioner OFF, push the button again. • This button takes priority over any other button. MODE - Push this button to cycle through the modes from COOL ¡ FAN ¡ HEAT¡ COOL. - COOL • Fan runs continually for normal cooling operation. - ENERGY SAVER • The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air temperature to determine if cooling is needed. - FAN • Fan operation without heating or cooling. - HEAT • Fan runs continually for normal heating operation. TEMPERATURE SETTING • Use this button to automatically control the temperature of the room. The temperature can be set within a range of 54° F to 86° F by increments of 2° F. • The setting appears in the display. TIMER - SHUT-OFF TIME • You will usually use shut-off time while you sleep. • If unit is running, use Timer to set number of hours until shut-off. • For your sleeping comfort, once Time is set, the Temperature setting will raise 2° F after 30 minutes, and once again after another 30 minutes. • Push Timer to cycle through the settings from 1 Hour ¡ 2 Hours ¡ ... ¡ 12 Hours maximum. Downloaded from www.Manualslib.com manuals search engine -8-