Lantronix EDS3000PS Command Reference - Page 68

6: Commands and Levels line (line:) level commands ( is the number of the line) auto show statistics Continuously displays line statistics. baud rate Sets the line speed. = the speed. Standard speeds include 1200, 2400, 4800, 9600, 19200, and so on. clear line counters Sets the serial counters to zero. clrscrn Clears the screen. command mode always Sets the current line to always be in command mode. command mode echo serial Disables user-defined serial boot string to be echoed in the CLI. string disable command mode echo serial Enables user-defined serial boot string to be echoed in the CLI. string enable command mode serial string Enables user to enter a custom string at boot time to enter command mode. command mode serial string Sets a string that can be entered at boot time to enter command mode. = text with possible binary characters. Within [] use binary decimal up to 255 or hex up to 0xFF. Within {} specify decimal milliseconds time delay. command mode signon message Sets a sign-on message that is sent from the serial port when the device boots and when the line is in command mode. = text with possible binary characters. Within [] use binary decimal up to 255 or hex up to 0xFF. command mode wait time Sets boot-up wait time for command mode serial string. = wait time. configure current settings Configures line with the current value of settings. data bits 7 Uses seven bits for data on the line. data bits 8 Uses eight bits for data on the line. default baud rate Restores the default speed of 9600 bits per second. default data bits Restores the default of eight data bits. default flow control Restores the default of no flow control. default parity Restores the default of no parity. default stop bits Restores the default of one stop bit. default threshold Restores the factory default threshold. default xoff char Restores the default xoff character on this line. default xon char Restores the default xon character on this line. exit Exits to the enable level flow control hardware Uses hardware (RTS/CTS) flow control on the line. flow control none Does not provide flow control on the line. flow control software Uses software (xon/xoff characters) flow control on the line. gap timer Sets the gap timer in milliseconds. If some data has been received, it will be forwarded after this time since the last character. kill session Kills command mode session on the Line line Enters the line level. = number of the line (serial port) to be configured. name Sets the name for this line. no clear line counters Restores the serial counters to the aggregate values. no command mode Disables command mode for the current line. no command mode signon Clears the signon message displayed at boot time and when entering message command mode. EDS3000 Command Reference 68