Lenovo PC 300 IBM PC300 (Type 2169) - Hardware Maintenance Manual (September 2 - Page 75
Does The Diagnostics Finish Without Any, Errors? Yes, Read Ahead., No, Go To Step
View all Lenovo PC 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
008 - DOES THE DIAGNOSTICS FINISH WITHOUT ANY ERRORS? (YES, READ AHEAD. NO, GO TO STEP 009.) q If the Diagnostics \ All Tests did not detect a failure but the system still indicates a failure: q Check all adapter card jumper settings. q Check all adapter cards switch settings. q Check all adapter card cables and connectors. q Make sure that all of the above are set correctly and show the correct voltages and continuity. Replace any defective cables or adapter cards. See "Power Supply Cable Connector Specifications" on page 129 and the layout of system board according the machine type in chapter 5. q Run the Diagnostics \ All Tests again. q If an error or other symptom is displayed, go to "Index of Symptoms, Messages, Error Codes, or Beeps" on page 74. q If no error can be detected or the symptom is intermittent, go to "Undetermined Problems" on page 104. q End 009 q If the last test stops and you cannot continue, first make sure all switches, power connectors, cables, and jumpers are set correctly and show the correct voltages and continuity. q Take note of any messages, error codes, beeps, or new symptoms. Go to "Index of Symptoms, Messages, Error Codes, or Beeps" on page 74. q If there is no error symptom or the error symptom is intermittent, go to "Undetermined Problems" on page 104. 73