Lenovo PC 300 IBM PC300 (Type 2169) - Hardware Maintenance Manual (September 2 - Page 91
IDE Secondary Channel Master and Slave Drives in BIOS
View all Lenovo PC 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
004 - IF THE NUMBER OF DISKETTE, HARD DISK, OR CD-ROM DRIVE IS NOT CORRECT, READ AHEAD; OR GO TO STEP 005. q Check the cable installation of all disk drives. q Diskette drive should be connected to the system board Floppy connector. (Please refer to the connectors and functions illustrated in chapter 5.) q IDE Primary Channel Master and Slave Drives in BIOS Setup should be connected to the system board primary IDE connector. (Please refer to the connectors and functions illustrated in chapter 5.) q IDE Secondary Channel Master and Slave Drives in BIOS Setup should be connected to the system board secondary IDE connector. (Please refer to the connectors and functions illustrated in chapter 5.) NOTE: The CD-ROM drive that comes with system unit should be configured as IDE Secondary Channel Master device. q Check the hard disk and CD-ROM drives jumper settings. See "3.5-In. Hard Disk Drive Jumper Locations" on page 133 and "CD-ROM Drive" on page 95. q Check the voltages of all disk drive power connectors. See "Power Supply Cable Connector Specifications" on page 129. q Correct the parameter settings under Disk Drives in the BIOS Setup. q In the BIOS Setup, check that the correct drive size is set for the flagged drive shown in the IDE sections of the Setuop utility.. q Load default settings. q If the problem remains, check the continuity on the drive and the cable and replace it if necessary. If that does not fix the problem, replace the system board. q End. 005 - q Select Diagnostics from the PC-Doctor diagnostics program main menu. Select and execute Floppy Disk Test if you want to test the diskette drive. Select and execute Hard Disk Test if you want to test the hard disk drive. q Select Interactive Tests from the PC-Doctor diagnostics program main menu, then select and execute CDROM/DVD Test if you want to test the CD-ROM drive. q If the diagnostics program did not detect a failure, but the system still displays a failure: 89