Lenovo ThinkCentre A30 Hardware Maintenance Manual (HMM) for ThinkCentre 2296, - Page 55
limitation
View all Lenovo ThinkCentre A30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
2. Install the drive into the bay. Align the screw holes and install two screws to secure the drive. Note: This illustration shows a CD drive installation. The hard disk drive and diskette drive is installed in the same manner except that the front bezel is not in place. 3. If the front bezel was removed, replace it by aligning the four plastic tabs and pressing the bezel into position. 4. Go to "Connecting the drive" on page 56. Type 8191 Drive bay information Any bay that does not have a drive installed has a static shield and bay panel installed. The following illustration shows the locations of the drive bays. The following table describes the drive height limitation for each drive bay. Bay 1 and Bay 2 - Maximum height: 43.0 mm (1.7 in.) Bay 3 and Bay 4 - Maximum height: 25.8 mm (1.0 in.) Chapter 6. Replacing FRUs 49