Lenovo ThinkServer RD330 Hardware Maintenance Manual - ThinkServer RD330 - Page 46
System board components, Refer to the following topics for information about the connector locations
View all Lenovo ThinkServer RD330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
1. Use one mini-SAS to mini-SAS signal cable. Connect the mini-SAS connector 1 on one end of the cable to the port 0 on the RAID card. Then, connect the mini-SAS connector 2 on the other end of the cable to the mini-SAS ports 0-3 on the backplane. 2. If your server has more than four hard disk drives installed, use the other mini-SAS to mini-SAS signal cable. Connect the mini-SAS connector 3 on one end of the cable to the port 1 on the RAID card. Then, connect the mini-SAS connector 4 on the other end of the cable to the mini-SAS ports 4-5 on the backplane. Refer to the following topics for information about the connector locations: • "Hot-swap hard disk drive backplane" on page 28 • "RAID card" on page 26 • "System board components" on page 32 System board components The following illustration shows the component locations on the system board. Figure 22. System board components 1 Front panel connector 2 Internal USB connector 1 3 Internal USB connector 2 4 Intelligent Diagnostics Module connector 17 Riser card assembly 1 slot 18 Riser card assembly 2 slot 19 Redundant power supply connector 1 20 Redundant power supply connector 2 32 ThinkServer RD330 Hardware Maintenance Manual