LevelOne GTL-5280 Manual - Page 172

3-14.10 QoS Control List Configuration The section shows the QoS Control List(QCL), which is made up of the QCEs. Each row describes a QCE that is defined. The maximum number of QCEs is 256 on each switch. Click on the lowest plus sign to add a new QCE to the list. Web Interface To configure the QoS Control List parameters in the web interface: 1. Click Configuration, QoS, QoS Contol List 2. Click the to add a new QoS Control List 3. Scroll all parameters and evoke the Port Member to join the QCE rules 4. Click the Apply to Apply the setting 5. If you want to cancel the setting then you need to click the Reset button. It will revert to previously Saved values Figure 3-14.10: The QoS Control List Configuration Parameter description:  QCE# : Indicates the index of QCE.  Port : Indicates the list of ports configured with the QCE.  Frame Type : Indicates the type of frame to look for incomming frames. Possible frame types are: Any: The QCE will match all frame type. Ethernet: Only Ethernet frames (with Ether Type 0x600-0xFFFF) are allowed. LLC: Only (LLC) frames are allowed. SNAP: Only (SNAP) frames are allowed IPv4: The QCE will match only IPV4 frames. IPv6: The QCE will match only IPV6 frames.  SMAC : Displays the OUI field of Source MAC address, i.e. first three octet (byte) of MAC address.  DMAC : Specify the type of Destination MAC addresses for incoming frame. Possible values are: 164