LevelOne GTL-5280 Manual - Page 251
VeriPHY
![]() |
View all LevelOne GTL-5280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
5-5.3 VeriPHY This section is used for running the VeriPHY Cable Diagnostics. Press to run the diagnostics. This will take approximately 5 seconds. If all ports are selected, this can take approximately 15 seconds. When completed, the page refreshes automatically, and you can view the cable diagnostics results in the cable status table. Note that VeriPHY is only accurate for cables of length 7 -140 meters.10 and 100 Mbps ports will be linked down while running VeriPHY. Therefore, running VeriPHY on a 10 or 100 Mbps management port will cause the switch to stop responding until VeriPHY is complete. Web Interface To configure a VeriPHY Cable Diagnostics Configuration in the web interface: 1. Specify Port which want to check. 2. Click Start. Figure 5-5.3: The VeriPHY Parameter description: Port : The port where you are requesting VeriPHY Cable Diagnostics. Cable Status : Port: Port number. Pair: The status of the cable pair. Length: The length (in meters) of the cable pair. 243
![](/manual_guide/products/levelone-gtl5280-manual-874a944/251.png)