LevelOne GTL-5280 Manual - Page 184

3-18 Loop Protection The loop Protection is used to detect the presence of traffic. When switch receives packet's(looping detection frame) MAC address the same as oneself from port, show Loop Protection happens. The port will be locked when it received the looping Protection frames. 3-18.1 Configureaion The section describes how to set Loop Protection. Web Interface To configure the Loop Protection parameters in the web interface: 1. Click Configuration,Loop Protection, Configuration 2. Evoke to select enable or disable the port loop Protection. 5. Click the Apply to Apply the setting 6. If you want to cancel the setting then you need to click the Reset button. It will revert to previously Saved values Figure 3-18.1: The Loop Protection Configuration. Parameter description: General Settings:  Enable Loop Protection: Controls whether loop protections is enabled (as a whole). .  Transmission Time: The interval between each loop protection PDU sent on each port. valid values are 1 to 10 seconds. 176