Maytag MGD5707TQ Use and Care Guide - Page 12
Make Gas Connection, Dryer
View all Maytag MGD5707TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
MAKE GAS CONNECTION 1. Remove the red cap from the gas pipe. 2. Using a wrench to tighten, connect the gas supply to the dryer. Use pipe-joint compound on the threads of all non-flared male fittings. If flexible metal tubing is used, be sure there are no kinks. A B......... A. Flared male thread B. Non-flared male thread NOTE: For [.P gas connections, you must use pipe-joint compound resistant to the action of [P gas. Do not use ]EFi.ON _ tape. A combination of pipe fittings must be used to connect Shown is a recommended connection. Your connection supply line type, size, and location. the dryer to the existing gas line. may be different, according to the 3. Open the shutoff valve in the supply line. [he valve is open when the handle is parallel to the gas pipe. A. Closed valve B. Open valve 4. lest all connections by brushing on an approved noncorrosive Bubbles will show a leak. Correct any leak found. leak-detection solution. CONNECT VENT 1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Check that the vent is secured to exhaust hood with a 4" (10.2 cm) clamp. 2. Move dryer into its final location. Do not crush or kink vent. 3. (On gas models) Check that there are no kinks in the flexible gas line. 4. Once the exhaust vent connection is made, remove the corner posts and cardboard. LEVEL DRYER Check the levelness of the dryer. Check levelness first side to side, then front to back. I A A. _" flexible gas connector B. _" dryer pipe C. _" to _" pipe elbow D. _" pipe-to-flare adapter fitting If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness. t,_¢,TEFLON is a registered trademalk of E.I. Du Pont De Nemours and Company. 12