Motorola 49901 Software Release Notes - Page 12

H.323 ISDN PRI/BRI Supplementary Services Support - All products

Page 12 highlights

New Features Part No. T0001-42, Rev C October, 2002 Page 12 of 103 These recommendations were determined in a controlled environment. In links with long delays adjustments may be required. A general rule would be to be bring the Window Subtractor value close to or equal with the "W' Packet window. This effectively allows the acknowledgments to be sent out faster accommodating the added delay. The new Window Subtractor parameter is downward compatible with previous releases. It can be set independently at one end of the link without effecting the remote node that may not have this parameter. In addition to the recommendations in the table above the following two parameters should be always be set as shown below: • Data queue upper threshold = 15 • Data queue lower threshold = 4 Note The Vanguard 7300 W Packet Window parameter's default has been changed from 2 to 7 in release 6.1 and greater. Improvements in Reporting and Diagnostics - All Products This feature adds reporting and diagnostic enhancements. Release 6.1 and greater allows up to 20 alarm to be displayed in the Fatal Error Report (FER). The alarms are now organized to provide more useful information. There is a new Alarms Throttling feature that controls the number and levels of generated alarms, similar to the Trap Throttling feature. CSU/DSU alarm capturing history is shown in port statistics. Alarms are generated when DSU signals change (NIS, BPV, DL, C+, C-, RS, LL, CL, IDL, CLK). For more information, refer to the Alarms and Reports Manual (Part Number T0005) and Vanguard Basics Manual (Part Number T0113). H.323 ISDN PRI/BRI Supplementary Services Support - All products Release 6.1 provides transparent support for H.323 ISDN PRI/BRI for Voice over IP, Voice over Frame Relay (VoFR) and SoTCP. PBX supplementary service messages and information elements are passed transparently over H.323. The passing of Supplementary Service does not operate with third party equipment. This feature operates with Vanguard products only. For more information about H.323 ISDN PRI/BRI Supplementary Services, refer to the Vanguard Voice Manual (Part Number T0104-05). Multiple IP Ping (Remote Ping) Multiple IP Ping allows you create a maximum of ten ping entries. This created ping record is stored in CMEM. For a description of the new parameters, refer to the Vanguard Basics Manual (Part Number T0113). Vanguard 6435/6455 and 7300 Series ISDN PRI AT&T 4ESS Switch ISDN PRI AT&T switch type 4ESS is now supported in the Vanguard 7300 Series and 6435/6455 platforms. For more information, refer to the Vanguard Voice Manual (Part Number T0104-05).

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103

Part No. T0001-42, Rev C
October, 2002
New Features
Page 12 of 103
These recommendations were determined in a controlled environment. In links with
long delays adjustments may be required. A general rule would be to be bring the
Window Subtractor value close to or equal with the “W’ Packet window. This
effectively allows the acknowledgments to be sent out faster accommodating the
added delay.
The new Window Subtractor parameter is downward compatible with previous
releases. It can be set independently at one end of the link without effecting the
remote node that may not have this parameter. In addition to the recommendations in
the table above the following two parameters should be always be set as shown
below:
Data queue upper threshold = 15
Data queue lower threshold
=4
Note
The Vanguard 7300 W Packet Window parameter’s default has been changed
from 2 to 7 in release 6.1 and greater.
Improvements in Reporting and Diagnostics - All Products
This feature adds reporting and diagnostic enhancements. Release 6.1 and greater
allows up to 20 alarm to be displayed in the Fatal Error Report (FER). The alarms are
now organized to provide more useful information. There is a new Alarms Throttling
feature that controls the number and levels of generated alarms, similar to the Trap
Throttling feature. CSU/DSU alarm capturing history is shown in port statistics.
Alarms are generated when DSU signals change (NIS, BPV, DL, C+, C-, RS, LL,
CL, IDL, CLK). For more information, refer to the
Alarms and Reports Manual
(Part Number T0005) and
Vanguard Basics Manual
(Part Number T0113).
H.323 ISDN PRI/BRI Supplementary Services Support - All products
Release 6.1 provides transparent support for H.323 ISDN PRI/BRI for Voice over IP,
Voice over Frame Relay (VoFR) and SoTCP. PBX supplementary service messages
and information elements are passed transparently over H.323. The passing of
Supplementary Service does not operate with third party equipment. This feature
operates with Vanguard products only. For more information about H.323 ISDN
PRI/BRI Supplementary Services, refer to the
Vanguard Voice Manual
(Part Number T0104-05).
Multiple IP Ping (Remote Ping)
Multiple IP Ping allows you create a maximum of ten ping entries. This created ping
record is stored in CMEM. For a description of the new parameters, refer to the
Van-
guard Basics Manual
(Part Number T0113).
Vanguard 6435/6455 and 7300 Series ISDN PRI AT&T 4ESS Switch
ISDN PRI AT&T switch type 4ESS is now supported in the Vanguard 7300 Series
and 6435/6455 platforms. For more information, refer to the
Vanguard Voice Manual
(Part Number T0104-05).