Motorola 49901 Software Release Notes - Page 61

Vanguard 7300 MAC Address Filter Table Displays an Extra Hyphen

Page 61 highlights

Known Software Limitations Part No. T0001-42, Rev C October, 2002 Page 61 of 103 Vanguard 7300 MAC Address Filter Table Displays an Extra Hyphen The MAC Addresses displayed in the MAC Address filter table are not displaying correctly. (DRCaa23181) Workaround: Ignore the extra hyphen. Vanguard 7300, 6455 ISDN D-Channel Statistics Reports Statistics are incorrect for a Vanguard 7300 or 6455 node configured for ISDN PRI (5ESS, Network). When you connect the T1 PBX cable to the Interface, and the RED Alarm clears, the D-channel will go ACTIVE and all virtual ports report IDLE. If you do not place a call within one minute the D-Channel reports that it is DOWN and the voice ports report OUT OF SERVICE. If you place a call it will go through but, the statistics show that everything is DOWN. (DRCaa23214) Workaround: At present, there is no workaround. All Vanguard Platforms - Tunnel "Boot All" Boot all tunnels boots only the tunnels which Tunnel Table configuration has changed. If the tunnel includes compression or encryption, first boot the compression or encryption feature, then boot the specific tunnel. (DRFaa20567). Workaround: Boot Specific Tunnels. Vanguard 7300 Series H.323 Limitation on Number of Calls When a Vanguard 7300 is configured to use H.323, the total number of voice calls over all H.323 ports is limited to 216. (DRCaa23314) Workaround: Use 6.0S100 or if you require H.323 Supplementary Services Support, a 6.1 based software patch will be available shortly. Please contact your customer service representative.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103

Part No. T0001-42, Rev C
October, 2002
Known Software Limitations
Page 61 of 103
Vanguard 7300 MAC Address Filter Table Displays an Extra Hyphen
The MAC Addresses displayed in the MAC Address filter table are not displaying
correctly. (DRCaa23181)
Workaround:
Ignore the extra hyphen.
Vanguard 7300, 6455 ISDN D-Channel Statistics Reports
Statistics are incorrect for a Vanguard 7300 or 6455 node configured for ISDN PRI
(5ESS, Network). When you connect the T1 PBX cable to the Interface, and the
RED Alarm clears, the D-channel will go ACTIVE and all virtual ports report IDLE.
If you do not place a call within one minute the D-Channel reports that it is DOWN
and the voice ports report OUT OF SERVICE. If you place a call it will go through
but, the statistics show that everything is DOWN. (DRCaa23214)
Workaround:
At present, there is no workaround.
All Vanguard Platforms - Tunnel "Boot All"
Boot all tunnels boots only the tunnels which Tunnel Table configuration has
changed. If the tunnel includes compression or encryption, first boot the compression
or encryption feature, then boot the specific tunnel. (DRFaa20567).
Workaround:
Boot Specific Tunnels.
Vanguard 7300 Series H.323 Limitation on Number of Calls
When a Vanguard 7300 is configured to use H.323, the total number of voice calls
over all H.323 ports is limited to 216. (DRCaa23314)
Workaround:
Use 6.0S100 or if you require H.323 Supplementary Services Support,
a 6.1 based software patch will be available shortly. Please contact your customer
service representative.