Motorola 49901 Software Release Notes - Page 35
Detailed Port Statistics - Incorrect State, Vanguard 6400 Series Event Log Port Information
UPC - 786523499018
View all Motorola 49901 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Software Improvements Part No. T0001-42, Rev C October, 2002 Page 35 of 103 Figure 10 shows that the port statistics page reports the following conditions as the current port state: • Rx State = 0000 and Voice State = IDLE_UNCON - This means that the port has booted to the incorrect state. Figure 10. Detailed Port Statistics - Incorrect State If the Rx State = 0000 this means that: • the port has booted to an incorrect state • the port is not physically connected to a PBX Station or CO trunk This is fixed. Vanguard 6400 Series Event Log Port Information When a Vanguard 6455 is defaulted with an ISDN data card in slot 1 the node comes up and alarms appear in the event log for ports 51-53, even if a quad card is not installed. (Ports 51-53 are for the quad FXS/FXO card.) If you have a quad FXS port installed and configured in slot 2, and you remove this card and install a single FXO the log should show a problem. The node comes up, but there is no log that states "cannot boot ports 61-64 because of a hardware mismatch". (DRCaa23067) This is fixed. Vanguard 6455 PRI-DATA and PRI-Voice Alarm Errors Upon completion of a node boot, level one alarms are generated for every virtual port mapping table entry with Virtual Port Type configured as PRI-DATA or PRI-VOICE. Example: (1) 102 20-JUN-2001 08:25 Assert 897 vpmt.c (DRCaa22532) This is fixed.