Netgear DM111PSP-100NAS DM111PSPv2 User Manual - Page 9
Front Panel, Power, Ethernet, Internet, Front panel LED Icons, Table 1. - bridge mode
![]() |
View all Netgear DM111PSP-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Broadband ADSL2+ Modem DM111PSPv2 Front Panel The modem front panel has the status LEDs and icons shown in the following figure. Power Ethernet DSL Internet Figure 3. Front panel LED Icons The following table describes the LEDs and icons on the front panel from left to right. Table 1. LEDs LED Power Ethernet DSL Internet Description • Solid green. Power is supplied to the modem. • Solid red. POST (power-on self-test) failure or a device malfunction has occurred. • Off. Power is not supplied to the modem. • Restore factory settings. The LED blinks momentarily when the Restore Factory Settings button on the bottom of the unit is pressed for 6 seconds. The Power LED then blinks red three times when the Restore Factory Settings button is released and then turns green as the gateway resets to the factory defaults. • Solid green. The port has detected an Ethernet link with a device. • Blinking green. Data is being transmitted or received. • Off. No link is detected on the port. • Solid green. You have a DSL connection. In technical terms, the DSL port is synchronized with an ISP's network-access device. • Blinking green. Indicates that the broadband ADSL2+ modem is negotiating the best possible speed on the DSL line. • Off. The unit is off or there is no DSL connection. • Solid green. You have an Internet connection. If this connection is dropped due to an idle time-out but the DSL connection is still present, the light stays green. If the Internet connection is dropped for any other reason, the light turns off. • Blinking green. Data is being transmitted over the DSL port. • Solid red. The Internet (IP) connection failed. See No Internet Connection on page 67 for troubleshooting information. • Off. No Internet connection is detected or the device is in bridge mode (an external device handles the ISP connection). Hardware Setup 9
![](/manual_guide/products/netgear-dm111pspv2-dm111pspv2-user-manual-e5babb4/9.png)