Netgear FVS114NA FVS114 Reference Manual - Page 76
How to Set Up a Gateway-to-Gateway VPN Configuration, Table 5-1 on Advanced
![]() |
View all Netgear FVS114NA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Reference Manual for the ProSafe VPN Firewall FVS114 How to Set Up a Gateway-to-Gateway VPN Configuration Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC default parameters listed in Table 5-1 on page 5-4. If you have special requirements not covered by these VPNC-recommended parameters, refer to Chapter 6, "Advanced Virtual Private Networking" to set up the VPN tunnel. A FVS114 VPN Firewall VPN Tunnel B FVS114 VPN Firewall PCs PCs Figure 5-22: Gateway-to-Gateway VPN Tunnel Follow the procedure below to set the LAN IPs on each FVS114 to different subnets and configure each properly for the Internet. The LAN IP address ranges of each VPN endpoint must be different. The connection will fail if both are using the NETGEAR default address range of 192.168.0.x. In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1. 5-20 202-10098-01, April 2005 Basic Virtual Private Networking
![](/manual_guide/products/netgear-fvs114-fvs114-reference-manual-5307826/76.png)