Netgear RND4000 RND4000 User Manual - Page 67
Enable SNMP, service, Community, public, Trap destination, Hosts, allowed access, Apply
UPC - 606449053272
View all Netgear RND4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
NETGEAR ReadyNAS User Guide Figure 1-59 To set up SNMP service: 1. Select the SNMP tab to display the SNMP settings. 2. Select the Enable SNMP service check box. You can leave the Community field set to public, or specify a private name if you have opted for a more segregated monitoring scheme. 3. Enter a host name or an IP address in the Trap destination field. This is where all trap messages will be sent. The following system events generate a trap: • Abnormal power voltage • Abnormal board enclosure temperature • Fan failure • UPS connected • UPS detected power failure • RAID disk sync started and finished • RAID disk added, removed, and failure • Snapshot invalidated 4. If you wish to limit SNMP access to only a secure list of hosts, specify the hosts in the Hosts allowed access field. 5. Click Apply to save your settings. When you have saved the SNMP settings on the ReadyNAS, you can import the NETGEAR SNMP MIB to your SNMP client application. The NETGEAR MIB can be obtained from the included Installation CD or downloaded from the NETGEAR Support site at http://www.netgear.com/support. Configuring Your ReadyNAS v1.0, October 2007 1-55