Netgear WG602 WG602v3 User Manual - Page 51
Apply, Wireless Remote Access Point, Segment 1 - wireless g access point
UPC - 606449030730
View all Netgear WG602 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual 5. Click Apply to save your changes. The Remote Access Point MAC address will display in the Wireless Remote Access Point List. The following figure shows a point-to-point bridge between two wireless access points on two LAN segments. . AP1 Wireless PC Card in a Notebook Computer Internet Router 192.168.0.1 LAN Segment 1 PCs Point-to-Point Mode AP2 Wireless PC Card in a Notebook Computer Point-to-Point Mode Hub or Switch LAN Segment 2 PCs Figure 4-2 To set up this type of point-to-point configuration: 1. Configure AP1 in Point-to-Point mode with the MAC address of AP2 and deploy it on LAN Segment 1. If you check the Enable Wireless Client Association checkbox, wireless clients will also be able to use AP1. If the Enable Wireless Client Association checkbox is not selected, only computers on Ethernet LAN segment 1 will be able to use AP1 to communicate with AP2. 2. Configure AP2 in Point-to-Point mode with the MAC address of AP1 and deploy it on LAN Segment 2. Use the same security and channel settings as AP1. If you check the Enable Wireless Client Association checkbox, wireless clients will also be able to use AP2. If the Enable Wireless Client Association checkbox is not selected, only computers on Ethernet LAN segment 2 will be able to use AP2 to communicate with AP1. 3. Verify connectivity across the network. If you enabled wireless client association on both APs, a computer on either AP should be able to connect to the Internet or share files and printers of any other PCs or servers connected to the network. Advanced Configuration 4-3 v1.0, August 2006