Oki OF5800 Service Guide - Page 77
Adjustment Procedures, Initial Setting, Adjustment, Usage / Comments
![]() |
View all Oki OF5800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Service Manual for OF5800 Chapter 3 Adjustment Procedures Page: 61 Bit Initial Setting Adjustment Usage / Comments 7 0 Factory use only 6 1 Ring signal detect time Sets the time an incoming ring will not be 5 1 detected after hanging up in the Fax/Tel Ready 4 0 mode. 6 5 4 1 1 0 800 ms. 1 1 0 700 ms. 1 0 1 600 ms. 1 0 0 500 ms. 0 1 1 400 ms. 0 1 0 300 ms. 0 0 1 200 ms. 0 0 0 100 ms. 3 0 Number of rings Sets the number of rings in the Fax/Tel Ready 0: 1 ring mode. Incoming calls are answered according 1: 2 rings to this setting regardless or the number of rings chosen in the User Settings. 2 0 Dual ring detection: When enabled, the unit is able to auto answer 0:No an incoming ring with an off time of 120 - 1:Yes 600ms. 1 0 Long ring detection: Allows the unit to respond to an incoming ring if 0:No the ring on-time is longer than two seconds. 1:Yes 0 1 Ring frequency When disabled, the unit will not check the ring detection frequency of incoming rings. 0:No 1:Yes Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
![](/manual_guide/products/oki-data-of5800-service-guide-82947a4/77.png)