Oki OF5800 Service Guide - Page 83

Service Manual for OF5800 Chapter 3 Adjustment Procedures Page: 67 Bit Initial Setting Adjustment Usage / Comments 7 0 Program individual Allows individual setting of memory switches autodialer attributes. B:0 as attribute 1, B:1 as attribute 2 and B:2 as 0: No attribute 3 and B:3 as attribute 4 when 1: Yes one-touch and speed dial locations are programmed. 6 0 Relay broadcast 0: No 1: Yes 5 0 Proprietary handshake Enable the OKIFAX 5800 proprietary 0: No handshaking protocol. 1: Yes 4 0 Factory use only 3 0 Factory use only 2 0 Sending RTC signal when transmission is canceled 0: Yes 1: No 1 1 Cancel redial if T.4.1 or RTC signal is sent at the end of the T4.4 error occurs. transmission. when set at "0", the unit will send 0: Yes the RTC if the tx is canceled. No error will 1: No occur. When set at "1", an error will occur because RTC will not be sent at the end of a canceled transmission. 1 1 Cancel redial if T.4.1 or When set at "0" if a T.4.1 or a T.4.4 error T.4.4 error occurs. occurs, the unit will not retry the transmission 0: Yes 1: No Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)