Oki OKIPOS 407II ParallelBlack Users Guide - Page 11
Connecting Ethernet Cable
View all Oki OKIPOS 407II ParallelBlack manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3-2-4. Connecting Ethernet Cable When using an Ethernet cable that is 10 m or less, shielded cable is recommended. (1) Make sure the printer is turned off. (2) Affix the ferrite core onto the ethernet cable as shown in the illustration below. (3) Pass the fastener through the ferrite core. (4) Loop the fastener around the cable and lock it. Use scissors to cut off any excess. Ferrite core Ethernet cable 10 cm (maximum) Fastener (5) Connect the interface cable to the connector on the rear panel of the printer. - -
– ¶ –
3-2-4. Connecting Ethernet Cable
When using an Ethernet cable that is ±0 m or less,
shielded cable is recommended.
(±) Make sure the printer is turned off.
(2) Affix the ferrite core onto the ethernet cable as
shown in the illustration below.
(³) Pass the fastener through the ferrite core.
(´) Loop the fastener around the cable and lock it.
Use scissors to cut off any excess.
(µ) Connect the interface cable to the connector on
the rear panel of the printer.
Ferrite core
Ethernet cable
10 cm
(maximum)
Fastener