Oki OKIPOS 407II ParallelBlack Users Guide - Page 15
Connecting to a Peripheral Unit
View all Oki OKIPOS 407II ParallelBlack manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3-6. Connecting to a Peripheral Unit You can connect a peripheral unit to the printer using a modular plug. See "Modular plug" on page 58 for details about the type of modular plug that is required. Note that this printer does not come with a modular plug or wire, so it is up to you to obtain one that suits your needs. CAUTION Make sure that the printer is turned off and unplugged from the AC outlet and that the computer is turned off before making connections. (1) Connect the peripheral drive cable to the connector on the rear panel of the printer. CAUTION Do not connect a telephone line into the peripheral drive connector. Failure to observe this may result in damage to the printer. Also, for safety purposes, do not connect wiring to the external drive connector if there is a chance it may carry peripheral voltage. (2) Connect the ground wire. (Europe only) Take out the screw shown in the figure below, then fasten the ground wire terminal to the place where the screw was removed and tighten the screw. - 11 -