Oki OKIPOS 407II ParallelBlack Users Guide - Page 36

Adjustment value according to the paper you are using Paper thick-ness When using the paper roll with a core whose inside diameter (A):ø12, outside diameter (µm) (B):ø18 Detected diameter (C) (Approx. mm) Remained paper length (Approx. m) Level 1 Level 2 Level 3 Level 1 Level 2 Level 3 65 ø23 ø27 ø31 2.5 4.9 7.7 75 2.1 4.2 6.7 Paper thick-ness (µm) 65 75 85 95 105 130 150 When using the paper roll with a core whose inside diameter (A): ø25.4, outside diameter (B):ø32 Detected diameter (C) Remained paper length (Approx. mm) (Approx. m) Level 1 Level 2 Level 3 Level 1 Level 2 Level 3 ø36 ø40 ø44 2.8 6.4 10.4 2.4 5.5 9.0 2.1 4.9 7.9 1.9 4.4 7.1 1.7 4.0 6.4 1.4 3.2 5.2 1.2 2.8 4.5 C Note: 1) The adjuster is factory-set at level 1 on the horizontal layout and level 3 on the vertical/wall-mount lay- out. 2) The control switch or the memory switch A may be used to switch between the horizontal and vertical B (wall-mount) layouts. For instructions on setting the memory switch, refer to the separate Specifications Manual. 3) The detected diameter and remained paper length A given above are calculated values, and there may be some variances depending on the rolled state of the Paper roll core C paper or the actual mechanism. 4) If thick paper is used (paper thickness between 100 μm and 150 μm), the paper roll may loosen and cause variances in the detected values. Therefore, set the adjustor to Level 3 for horizontal layout. - 32 -