Panasonic CYVHD9401U 9" Overhead Monitor - Page 8

E N Before Installation G L I S H Safety Installation Diagram 1 ≥ This unit opens and closes at the maximum dimensions given below. Approximately 150 mm {515/16q}* Installation angle: Less than 20˚ Approximately 300 mm {1113/16q } Maximum Approximately 120˚ 300 mm {1113/16q } * Install the product in such a way as to maintain the distances shown even when the display unit is rotated by 30˚ toward the front seat headrest (page 15). WARNING: Have a professional technician wire and install the product. Professional skill and experience is required to wire and install the product. Improper installation could result in failure of safety equipment resulting in accident and injury. For safety's sake, always ask the store from which you purchased the product to install and wire it for you. E N G L I S Perform the adjustment below in order to provide the installation range shown in the figure on the left. H Open the Display Unit [PUSH OPEN] 2 Display Unit Lateral Angle Adjustment Maximum 120x 30x 30x 1 Push the display release button [PUSH OPEN] until the display is unlocked. (Press the button with one hand while holding the display with the other.) 2 Open the display unit by both hands until a comfortable viewing angle is reached. Close the Display Unit Move the display unit by both hands until the display release button is locked. Note: ≥ Always use both hands to open or close the display unit. ≥ Always check that the display release button is locked after closing the display unit. ≥ If the display unit cannot be locked, be sure to consult your dealer and remedy the situation. You can swivel it to the left and right, 30e each way. Hold the display unit by the non-slip part in the upper half of it and adjust its lateral angle. 14 CY-VHD9401U/L CY-VHD9401U/L 15