Panasonic SLPR300 SLPR300 User Guide - Page 49
Troubleshooting
![]() |
View all Panasonic SLPR300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Troubleshooting English Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem: In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail [email protected], or web site (http://www.panasonic.com). In Canada, contact Panasonic Canada Inc. Customer Care Centre at 905-624-5505, web site (www.panasonic.ca), or an Authorized Service Centre closest to you. COMMON CD PLAYER Symptom Cause Remedial action/check Ref No sound. • A CD-R or CD-RW with nothing recorded on it has been inserted. ("BLANK DISC" is displayed.) • Replace the disc with one on which tracks have been recorded. The time display flashes in the dis- • A power failure has occurred or the • Set the clock and re-program the 41 play window. power cord has been disconnected. timer. Play fails to start • The CD has been inserted upside down. • Insert it properly with the label side 14 facing up. • Condensation has formed on the lens. • Turn on the power and wait for a couple of hours. Specific parts are not played properly. • The CD is scratched. • Replace the CD. 14 Recording is not possible • The CD-R or CD-RW was loaded in • Load the disc with the label side up. 15 the tray upside-down. • The CD-R or CD-RW is already • Replace with a disc that can be 38 finalized. recorded on. • Further recording on a finalized CD- RW is only possible if the Unfinalize function is used. • The source being copied is already a • Perform analog recording of the 24 digital copy itself. source. • There is dust or scratches on the sur- • Clean the disc using a commercially 23 face of the disc. available disc cleaner. If this is not effective, replace the disc. Timer fails to start. • Present time is not correct. • Set the time properly. 41 • The timer display fails to appear. • Set the timer properly. CDR No remote control operations. • The batteries in the remote control have discharged. • The remote control sensor is exposed to direct sunlight or some other intense source of light. • Replace them with two fresh batter- 12 ies (AA (15F), R6, SUM-3). • Move the unit so that the sensor is 12 not exposed to direct sunlight, a lighting fixture or some other intense source of light. REMOTE CONTROL TIMER If the unit fails to operate properly even when the remedial action suggested above has been taken: This unit uses a microcomputer to perform a large number of operations. If it fails to operate no matter which button is pressed, disconnect the power cord, and then wait a few moments before re-connecting it. Then set the time and re-program the timer. Notes • If something important is going to be recorded, always test-record first to check that the recording turns out properly before proceeding with the actual recording. • The manufacturer assumes no liability whatsoever for any damages resulting from missed opportunities or accidental erasure that occurs while conducting recording or play operations due to malfunctioning of or trouble in the unit, or for any incidental damage. "' RQT6087
![](/manual_guide/products/panasonic-slpr300-slpr300-user-guide-ff74428/49.png)