Pfaff creative stylist MN 110 Manual - Page 17

Inserting The Bobbin Case Into, The Rotary Hook, Removing The Bobbin

Get Pfaff creative stylist MN 110 PDF manuals and user guides View all Pfaff creative stylist MN 110 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

INSERTING THE BOBBIN CASE INTO THE ROTARY HOOK Note: When inserting the bobbin case into the rotary hook, make sure the thread tail is no longer than 3 inches (7 cm). A longer tail can wrap around the shaft 1 and create a buildup of thread. If the thread is not long enough, the needle will be unable to grab it. • Hold the bobbin case by the bobbin case release latch with the pigtail facing up. • Insert the bobbin case into the rotary hook by aligning bobbin case with the rotary hook groove (1). • Push in the bobbin case slightly and make sure the bobbin case clicks into place. • Close the bobbin housing unit. REMOVING THE BOBBIN 1. Open the bobbin housing unit. 2. Identify the thread hook. If thread hook is not forward, then pull it forward. Note: Do not pull thread hook beyond its capacity. It only moves to a certain extent. 3. Grab the bobbin case by the bobbin case release latch. 4. Gently remove the bobbin case from the machine. 5. Remove the empty or nearly empty bobbin from the bobbin case and discard or rewind. PREPARATIONS - 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
PREPARATIONS –
17
INSERTING THE BOBBIN CASE INTO
THE ROTARY HOOK
Note: When inserting the bobbin case into the rotary
hook, make sure the thread tail is no longer than 3
inches (7 cm). A longer tail can wrap around the shaft
and create a buildup of thread. If the thread is not long
enough, the needle will be unable to grab it.
•
Hold the bobbin case by the bobbin case release
latch with the pigtail facing up.
•
Insert the bobbin case into the rotary hook
by aligning bobbin case with the rotary hook
groove (1).
•
Push in the bobbin case slightly and make sure
the bobbin case clicks into place.
•
Close the bobbin housing unit.
REMOVING THE BOBBIN
1.
Open the bobbin housing unit.
2.
Identify the thread hook. If thread hook is not
forward, then pull it forward.
Note: Do not pull thread hook beyond its capacity. It only
moves to a certain extent.
3.
Grab the bobbin case by the bobbin case release
latch.
4.
Gently remove the bobbin case from the
machine.
5.
Remove the empty or nearly empty bobbin from
the bobbin case and discard or rewind.
1