Pfaff creative stylist MN 110 Manual - Page 25

HOOPING THE CAP 1. Take the cap hoop and connect the open metal notch to the center tab on the cap station. 2. Slide and push the cap hoop towards the cap station. 3. Make sure all three spring locks are connected. 4. Unfasten the flexible metal band and position it to the left of the cap hoop. 5. Pull back the sweatband of the cap. 6. Place the backing below the metal tab. 7. Slide in the sweatband between the metal tab and the backing. 8. Make sure extra fabric is out of the way. 9. Position the flexible metal band back over the bill of the cap. 1. Connect the clasp to the cap ring latch and snap it into place. 11. To remove from the cap station, release the three latches positioned. REMOVING THE CAP HOOP FROM THE CAP DRIVER 1. Release the three latches on the cap driver. 2. Rotate the cap hoop 90 degrees to either the left or right. 3. Slide the cap hoop away and off from the cap driver. REMOVING THE CAP DRIVER FROM THE EMBROIDERY ARM 1. Untighten and remove each screw. 2. Disengage the cap driver from its connection to the metal dowels. 3. Slide the cap driver away from the embroidery machine. ATTACHING THE CAP HOOP TO THE CAP DRIVER 1. Rotate the cap hoop 90 degrees to either the left or right. 2. Push the hoop onto the embroidery arm until the cap hoop connects to the cap driver. 3. Rotate the cap hoop back into an upward position with the bill of the cap facing upwards. 4. Align the center metal tab on the cap driver with the metal opening of the cap hoop. 5. Grab the cap driver from the back. 6. Slide and push the cap hoop towards the cap driver. 7. Make sure all three spring locks are connected. PREPARATIONS - 25