Pioneer VSX81TXV Owner's Manual - Page 55

Other connections 08 Switching components on and off using the 12 volt trigger You can connect a component in your system (such as a screen or projector) to this receiver so that it switches on or off using a 12 volt trigger when you select an input function. However, you must specify which input functions switch on the trigger using the The Input Setup menu on page 58. Note that this will only work with components that have a standby mode. 12V TRIGGER IN 1 DIGITAL OPTICAL MULTI-ROOM & SOURCE ROOM 2(ZONE 2) OUT IR IN ANTENNA OUT IN 2 OUT HDMI XM IN IN 1 (DVR/ VCR1) IN 2 (TV/SAT) IN 3 (CD) ASSIGNABLE 13 CONTROL OUT IN COMPONENT VIDEO Y PB PR IN 1 Y PB PR IN 2 Y PB PR Y PB PR ASSIGNABLE 1 3 RS-232C S-VIDEO iPod IN IN IN OUT IN VIDEO AM LOOP L OUT PRE OUT CENTER L L (Single) IN 3 R R SUB R SUR- SURROUND FRONT WOOFER ROUND BACK 12V TRIGGER (DC OUT 12 V / 50 mA MAX) OUT IN MONITOR MULTI-ROOM & SOURCE OUT MONITOR ROOM 2(ZONE 2) OUT R L • Connect the 12V TRIGGER jack of this receiver to the 12V trigger of another component. Use a cable with a mono mini-plug on each end for the connection. • The trigger maximum power is DC OUT 12V/50mA. After you've specified the input functions that will switch on the trigger, you'll be able to switch the component on or off just by pressing the input function(s) you've set in The Input Setup menu on page 58. Using this receiver with a Pioneer plasma display If you have a Pioneer plasma display, you can use an SR+ cable1 to connect it to this unit and take advantage of various convenient features, such as automatic video input switching of the plasma display when the input is changed.2 CONTROL OUT VSX-81TXV Pioneer plasma display IN 1 DIGITAL OPTICAL MULTI-ROOM & SOURCE ROOM 2(ZONE 2) OUT IR IN ANTENNA OUT IN 1 IN 2 (DVR/ VCR1) IN 2 (TV/SAT) OUT HDMI IN 3 (CD) ASSIGNABLE 13 CONTROL OUT XM IN IN AUDIO IN L IN 1 (DVD/LD) R IN 2 (DVR/VCR2) CD COAXIAL ASSIGNABLE 12 COMPONENT VIDEO Y PB PR IN 1 Y PB PR IN 2 Y PB PR Y PB PR ASSIGNABLE 1 3 RS-232C S-VIDEO iPod IN IN IN OUT IN VIDEO OUT IN IN IN OUT IN CD-R/TAPE/MD DVD/LD TV/SAT DVR/VCR1 AM LOOP L C OUT IN 3 R S FRONT W OUT IN OUT IN DVR/VCR2 Important • If you connect to a Pioneer plasma display using an SR+ cable, you will need to point the remote control at the plasma display remote sensor to control the receiver. In this case, you won't be able to control the receiver using the remote control if you switch the plasma display off. • Before you can use the extra SR+ features, you need to make a few settings in the receiver. See The Input Setup menu on page 58 and Multi-Room and IR receiver setup on page 59 for detailed instructions. Note 1 The 3-ringed SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Customer Support division for more information on obtaining an SR+ cable (you can also use a commercially available 3-ringed mini phone plug for the connection). 2 This receiver is compatible with all SR+ equipped Pioneer plasma displays from 2003 onward. 55 En