Pioneer VSX81TXV Owner's Manual - Page 63
Using other functions, Dimming the display, Switching the speaker impedance, Checking your system
UPC - 012562811048
View all Pioneer VSX81TXV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Using other functions 10 • Press RECEIVER then press SLEEP repeatedly to set the sleep time. 30 min 60 min Off 90 min • You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle through the sleep options again.1 Dimming the display You can choose between four brightness levels for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds. CD-R/TAPE HDMI2 XM RADIO ROOM 2 iPod HDMI1 TUNER RECEIVER SLEEP SR+ VIDEO SEL DIMMER DIALOG E S.RETRIEVER ANALOG ATT MIDNIGHT/ LOUDNESS D ACCESS • Press RECEIVER then press DIMMER repeatedly to change the brightness of the front panel display. Switching the speaker impedance We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating. Use the front panel controls to do this. • With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button. Each time you do this, you switch between the impedance settings: • SP 6 OHM - Use this setting if your speakers are rated at 6 Ω. • SP 8 OHM - Use this setting if your speakers are rated at 8 Ω or more. 1 Press STATUS to check the system settings. These appear on both the OSD and the front panel display.2 S TAT U S DOLBY DIGITAL 3/2.1 PCM 96+DOLBY PLII MS Signal Select : AUTO SBch Processing: OFF Retriever : ON Video Select : OFF MCACC Position : M1 Room 2 : DVD The front panel display shows each of the following settings for three seconds each: Input source Signal select Sound Retriever MCACC Position Listening mode Surround Back Processing Video Select ROOM 2 2 When you're finished, press STATUS again to switch off the display. Resetting the system Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down the front panel TONE button, press and hold STANDBY/ON for about three seconds. The display shows RESET?. 3 Press the front panel ENTER button. The display shows RESET OK?. 4 Press SYSTEM SETUP to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. • Note that all settings will be saved, even if the receiver is unplugged. Checking your system settings Use the status display screen to check your current settings for features such as surround back channel processing and your current MCACC preset. AUDIO SUBTITLE HDD DISP CH STATUS SIGNAL SEL SBch DVD CH STEREO MULTI OPE THX STANDARD ADV.SURR SHIFT PHASE MCACC S.DIRECT Note 1 You can also switch off the sleep timer simply by switching off the receiver. 2 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on. 63 En