Ricoh 402054 Operating Instructions - Page 25
Connecting to the Computer, Connecting with SCSI Interface, About the SCSI Interface
UPC - 026649020544
View all Ricoh 402054 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Connecting to the Computer Connecting to the Computer This scanner can be connected to the computer with either a SCSI, USB, or IEEE1394 interface. An optional board will be required to connect with IEEE1394. Important ❒ Do not turn the power of the scanner ON before the software installation. If you run the "Found New Hardware Wizard" beforehand, you will not be able to in- 2 stall the software correctly. When the "Found New Hardware Wizard" started before the installation, click the [Cancel] button to discontinue the wizard. Connecting with SCSI Interface Standard, you can connect the scanner to two computers at the same time. One with the SCSI interface, and one with the USB 2.0 interface. Though, you cannot use the scanner at the same time from two computers. Interfaces are switched automatically when you change from one of the computer to the other. When the IEEE1394 interface board of the option is installed, you can connect the scanner to three computers at the same time. One with a SCSI interface, and two with the optional IEEE1394 interface. Though, you cannot use the scanner at the same time from three computers. Interfaces are switched automatically when you use any one of the computers. About the SCSI Interface Connection of this scanner to the SCSI (Small Computer System Interface) is as follows: • This scanner is compliant for SCSI-3. You can daisy chain with SCSI-1/2 compliant devices as well. The SCSI connecter of this scanner is male 50pin halfpitch pin type. Use the shielded SCSI-2/3 cable compliant with ANSI (American National Standard Institute). Confirm in advance that some combination of the SCSI cable and SCSI board on the computer may cause an incorrect scanner operation. • This scanner is compliant for SCAM (SCSI Configured Automatically). If you use SCAM corresponding to SCSI board and driver for your computer, the SCSI ID will be set automatically. ⇒ p.23 "Setting the SCSI ID Automatically" • This scanner has a built-in terminator. Set the DIP switches properly when you connect the scanner with the SCSI interface. Important ❒ Using other cable than ANSI compliant SCSI-2/3 shielded cable, may possibly bring about malfunction or electromagnetic wave interference above VCCI rules. ❒ Connect a SCSI cable shorter than 4.9feet (1.5m) for the SCSI-3 (Ultra-SCSI), and a 9.8feet (3m) cable for the SCSI-2, including the cable length inside your computer. ❒ Some combinations of the SCSI board of your PC and daisy-chained periph- erals might cause an incorrect operation. Please contact and ask your service representative about the recommended SCSI board. 21