Ricoh CL3500N Quick Installation Guide - Page 430

Monitoring and Configuring the Printer ❖ Changing the Interface msh> ifconfig "interface" up • You can specify either the Ethernet interface or IEEE 802.11b interface when using the optional IEEE 802.11b interface unit. You cannot specify the IEEE 1394 interface. The following explains how to configure an IP address 192.168.15.16 on Ethernet interface. msh> ifconfig ether 192.168.15.16 The following explains how to configure a subnet mask 255.255.255.0 on Ethernet interface. msh> ifconfig ether netmask 255.255.255.0 ❒ To get the above addresses, contact your network administrator. ❒ Use the default configuration if you cannot obtain setting addresses. ❒ The IP address, subnet mask and broadcast address are the same as that for the ethernet interface and IEEE 802.11b interface. ❒ When installing the optional 1394 Interface board, set the IP address and sub- net mask so that it does not overlap with the ethernet interface or the IEEE 1394 interface. ❒ TCP/IP configuration is the same for both Ethernet and IEEE 802.11b interface. If interfaces are changed, the new interface inherits the configuration. ❒ Use "0x" as the initial two letters of a hexadecimal address. info Use the "info" command to display printer information such as paper tray, output tray, and printer language. ❖ Printer information display msh> info For details about displayed contents, see p.210 "Getting Printer Information over the Network". ipp Use the "ipp" command to configure IPP settings. ❖ Viewing settings The following command displays the current IPP settings: msh> ipp Example output: 190