Sanyo PLC-WL2503 RS232C Expand - Page 19

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications 8.4.5 CF_SHARP Command Command "CF_SHARP_%1"[CR] "000~015 Directly select Sharpness setting value %1 "UP Current Sharpness setting value + 1 "DN Current Sharpness setting value - 1 Details Set Sharpness value of user control The value set by this command will not be saved to projector. Therefore, when turning into Standby status or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.6 CF_GAMMA Command Command "CF_GAMMA_%1"[CR] "000~015 Directly set Gamma setting value %1 "UP Current Gamma setting value + 1 "DN Current Gamma setting value - 1 Details Set Gamma value of user control The value set by this command will not be saved to projector. Therefore, when turning into Standby status or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.7 CF_WBAL - Command Command "CF_WBAL-%1_%2"[CR] Red %1 Green Blue "000~063 Directly select Color value specified by White Balance%1 %2 "UP Current Color value set by White Balance%1 + 1 "DN Current Color value set by White Balance%1 - 1 Details Set Color value set by White Balance%1 of user control The value set by this command will not be saved to projector. Therefore, when turning into Standby status or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 18/72