Sanyo PLC-WL2503 RS232C Expand - Page 26

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications 8.6.2 CF_SOURCE Command Command "CF_SOURCE_%1"[CR] Input is Computer 1 "ANALOG" --------- Select Analog Input "YPBPR Select Component Input "SCART Select Scart Input "UP Switch Input as follows Analog →YPBPR →Scart →... "DN Switch Input as follows Scart →YPBPR →Analog →... Input is Computer 2 ""ANALOG" --------- Select Analog Input "UP" "DN" Projector accepts parameter "UP"/"DN" but no operation is made. %1 "HDMI Select HDMI Input Input is HDMI "UP" "DN" Projector accepts parameter "UP"/"DN" but no operation is made. Input is Video "VIDEO Select Composite Video Input "UP" "DN" Projector accepts parameter "UP"/"DN" but no operation is made. Input is S-video S-VIDEO Select S-video Input "UP" "DN" Projector accepts parameter "UP"/"DN" but no operation is made. Details Select Source of currently selected Input When Input specified by %1 is inappropriate for selected Input, the projector returns "101" and the command is not executed. This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.6.3 CF_INPUT1 Command Command "CF_INPUT1_%1_"[CR] "ANALOG Select Analog RGB Input %1 "YPBPR Select Component "SCART Select SCART Details Select Input - Computer 1 and source specified in %1 at once. This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.6.4 CF_INPUT2 Command Command "CF_INPUT2_%1_"[CR] %1 "ANALOG Select Analog RGB Input Details Select Input - Computer 2 and source specified in %1 at once. This command is available in normal Power ON status. Projector returns "101" by selecting Computer 2 while Monitor out is selected in Terminal menu. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 25/72