Sanyo PLC-WL2503 RS232C Expand - Page 20
CF_COLTEMP Command, CF_PROGV Command, 4.10 CF_NZRED Command
![]() |
UPC - 086483079627
View all Sanyo PLC-WL2503 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications 8.4.8 CF_COLTEMP Command Command "CF_COLTEMP_%1"[CR] "000" ------ Xlow %1 "001" ------ Low "002" ------ Mid "003" ------ High Details Set Color Temperature. (Available only in the normal Power ON status) The value set by this command will not be saved to the projector. Therefore, when turning into Standby status or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.9 CF_PROGV Command Command "CF_PROGV_%1"[CR] "FILM" -------- Select Progressive Mode FILM "L1 Select Progressive Mode L1 "L2 Select Progressive Mode L2 %1 "OFF" --------- Cancel Progressive scan "UP Switch Progressive mode forward OFF → L1 → L2 → FILM → OFF "DN Switch Progressive mode backward OFF → FILM → L2 → L1 → OFF Details Set / cancel Progressive scan The value set by this command will not be saved to projector. Therefore, when turning into Standby status or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.10 CF_NZRED Command Command "CF_NZRED_%1"[CR] "OFF" ------- Cancel Noise Reduction "L1" --------- Noise Reduction for moving image "L2" --------- Noise Reduction for still image %1 "UP Switch Progressive mode forward OFF → L1 → L2 → FILM → OFF "DN Switch Progressive mode backward OFF → FILM → L2 → L1 → OFF Details Noise Reduction based on frame correlation Select L1 or L2 depending on motion detection L2 is more effective in reducing noise than L1, however, L2 can have a blur in moving image The value set by this command will not be saved to projector. Therefore, when turning into Standby status or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 19/72
![](/manual_guide/products/sanyo-plcwl2503-rs232c-expand-d2dcdde/20.png)