Sanyo PLC-WL2503 RS232C Expand - Page 40

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications 8.10.17 CF_P-MANETIME Command Command "CF_P-MANETIME_%1"[CR] "01" ~ "30 Directly select setting time by the minute "UP Plus one minute (01 → 02 → → 30 → 01) "DN Minus one minute(30 → 29 → → 01 → 30) Details Set Power Management time The status set by this command is stored in EEPROM and its setting is effective after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.18 CF_ON-STA Command Command "CF_ON STA_%1"[CR] "ON Set Direct on active "OFF Set Direct on inactive %1 "UP Switch setting (On → Off → On → ) "DN Switch setting (On → Off → On → ) Note) "UP" and "DN" behave the same. Details Set/Cancel Power ON Start The status set by this command is stored in EEPROM and its setting is effective after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.19 CF_PTIMEMODE Command Command "CF_PTIMEMODE_%1"[CR] %1 "COUNTUP Select Count up "COUNTDN Select Countdown Details Set operation mode of P-timer. The status set by this command is stored in EEPROM and its setting is effective after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.20 CF_PTIMER Command Command "CF_PTOMER_%1"[CR] "START Execute P-timer "STOP Pause P-timer %1 "RESTART Restart P-timer "RST Reset P-timer "EXIT Terminate P-timer function Details Control P-timer. This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 39/72