Sharp IT23M1U Operation Manual - Page 57
Instructions for attaching a VESA-compliant mount - stand
![]() |
View all Sharp IT23M1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
English Français Deutsch Instructions for attaching a VESA-compliant mount An arm or stand based on the VESA standard (commercially available) can be attached to the monitor. Procurement of the arm or stand is at the customer's discretion. Arms or stands able to be used Attachments must satisfy the following. - Compatible with the VESA standard. - The six screw holes on the section to be attached have a gap of 100 mm between them. - Not be likely to fall off or break off after being attached to the monitor. How to attach the arm or stand - Be careful not to over bend the cable or add extension cords as this could lead to malfunction. - While following these instructions, please also refer to the installation instructions in the operation manual included with the arm or stand. CAUTION! - Be careful not to get your fingers pinched between the display and stand nor to let the stand drop. These could lead to injury. 1. Remove the cables. 2. Spread out a soft cloth on a suitable horizontal surface. Being careful not to damage the monitor, gently lay the monitor on it display-side down. 3. Remove the two screws and then remove the rear cover of the stand. 4. Remove the six screws and then remove the stand from the monitor. Notes: - The stand is specially made for use with this monitor. Once having removed the stand, never attempt to attach it to another equipment. - Once having removed the screws, store them together with the stand and if the stand is ever re-attached be sure to use the original screws. Using different screws could lead to a malfunction. 5. Attach the arm to the monitor with the six screws. Italiano Español English IT-23M1U_gb_02.P65 55 Note: - The screws used to attach the arm should be M4 screws with a length of 6 mm - 8 mm (0.24" 0.31") protruding from the surface to be attached. Using different screws could cause the monitor to fall off or to be internally damaged. 6 mm - 8 mm (0.24" - 0.31") Screw used to attach arm Arm Part of monitor to which arm is attached E55 2004/08/20, 10:44
![](/manual_guide/products/sharp-it23m1u-operation-manual-c0e3492/57.png)