Sharp LC-M3700 LC-M3700 Operation Manual - Page 25

Mounting Options (Continued) AN-37AG1 Wall-Mount Bracket Installation See the bracket instructions for details. Mounting precautions Special techniques are required to mount this monitor, so be sure to rely on a specialist for mounting work. The customer should never perform any of this work himself or herself. Our company will bear no responsibility for accidents or injuries caused by improper mounting or handling. Installing wall-mount bracket 1. Determine the location where the base bracket will be installed. G Take a washer about the size of a coin with a string and align it perpendicular to the base bracket. G Use a pencil, etc., to mark the two screw hole locations. Cellophane tape, etc. Wall-mount bracket unit installation hooks Perpendicular reference line Perpendicular reference line Base bracket shaped screw holes Use a pencil, etc., to mark the screw hole position on the wall behind the bracket. Display screen center position Use this as a reference for the display height position. Marking A Align horizontally and vertically until the string lies on top of the vertical reference line. 2. Loosely screw in the screws. G Temporarily remove the base bracket from the wall and loosely screw in 2 off-the-shelf screws in the screw hole positions marked on the wall. At this time, the screw heads should extend several millimeters above the wall so that the base bracket can be hung on the screw heads. G Hang the base bracket on the installed screws, check to make sure the bracket is not sagging to the left or right, and then firmly tighten the screws. Use off-the-shelf screws to secure the remaining screw holes (14 to 18 screws). Min. 4mm Wall A B US
24 Base bracket Use the weight with the string used in Step 1 to make sure the bracket is perpendicular.