Sony PDWHR1 User Manual (PDW-HR1 Operation Manual Ed. 1 Rev. 2 for Version 2.0 - Page 127
Command list, To log in, Standard commands
View all Sony PDWHR1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Note An FTP client that supports UTF-8 is required to use Unicode characters other than ASCII characters. Command prompt FTP commands do not support UTF-8. To log in If this unit is connected to a remote computer with a FAM connection, first exit file operations on the FAM connection (see page 124). 1 Load a disc into this unit and put the unit into the following state. • Recording, playback, search and other disc operations (see page 55): Stopped • THUMBNAIL/ESSENCE MARK button (see page 17): Off • Disc access by Lock or Delete All Clips, Format Disc, and so on in the Disc Menu (see page 70): Stopped Note Login is not possible unless a disc is loaded and the unit is in the state described above. 2 Start the command prompt. 3 Enter "ftp ", and press the Enter key. ( refers to a space.) For example, if the IP address of this unit is set to "192.168.001.010", enter "ftp 192.168.1.10". Refer to the Windows help for more information about the FTP command. If the connection succeeds, you are prompted to enter a user name. 4 Enter the user name "admin" and press the Enter key. When the user name is verified, you are prompted to enter a password. 5 Enter the password and press the Enter key. The password is set to "pdw-hr1" when the unit is shipped from the factory. The login is complete when the password is verified. See page 127 for the FTP protocol commands supported by this unit. If the connection times out This unit terminates FTP connections if no command is received within 90 seconds of the last command. If this occurs, log out (see the next section) and repeat steps 2 to 4. Note If you power this unit off during an FTP connection, the data transferred thus far is discarded. To log out To log out after finishing file operations, enter "QUIT" at the command prompt and press the Enter key. Command list The FTP protocol commands supported by this unit include standard commands (see the next section) and extended commands (see page 130). Notes • To execute FTP commands, you must install application software with FTP function on your computer. • The commands supported by application software vary. • In the command syntax, means a space, entered by pressing the space bar, and means a new line, entered by pressing the Enter key. Standard commands USER Send this command to begin the login process. Command syntax: USER Input example: USER admin PASS After sending the USER command, send this command to complete the login process. Command syntax: PASS Input example: PASS pdw-hr1 QUIT Terminates the FTP connection. If a file is being transferred, terminates after completion of the transfer. Command syntax: QUIT PORT Specifies the IP address and port to which this unit should connect for the next file transfer (for data transfer from this unit). Command syntax: PORT • h1 (most significant byte) to h4 (least significant byte): IP address Chapter 7 File Operations 127 FTP File Operations