Sony RM AV3000 Operating Instructions - Page 21
on the other remote control until, Repeat Steps 5 and 6 to teach - remote commander
UPC - 027242599826
View all Sony RM AV3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
To change the Label keys, press the Mode Display key (in this case, VCR) repeatedly. Each time you press the VCR key, the display of the Label keys changes as follows. VCR When teaching on the button that is not on the LCD Only "LEARN" flashes. 6 Press and hold down the button on the other remote control until you hear a beep. (If you release the button before you hear a beep, the signal may not be learned correctly.) Note on the flashing display The keys or buttons that are already preset for that component flash twice while those that are not preset flash once. To change the name of the Label key Follow the procedure on page 23. To change the component name on the Mode Display key See page 24. To change the function display of the key Follow the procedure on page 23. 5 Press the key or button on the Commander you want to "teach". "LEARN" flashes and the only pressed key remains on the display. "LEARN" stops flashing and stays lit. When the command has been learned successfully, the learned keys stay lit and the other learnable keys flash. If "NG" flashes on the display Learning did not succeed. Try Steps 5 and 6 again. 7 Repeat Steps 5 and 6 to teach functions to other keys or buttons. To learn another component's remote control signal Select the component in Step 4, and then follow Steps 5 and 6 to perform learning. 8 Press COMMANDER OFF. COMMANDER OFF If you keep COMMANDER OFF pressed for more than 2 seconds The Commander turns off. If you keep COMMANDER OFF pressed for less than 2 seconds The Commander returns to the previously by set mode. Continued 21