Sony RM AV3000 Operating Instructions - Page 22
When you teach the signals of an, VOLUME +/ - or MUTING buttons - remote code
UPC - 027242599826
View all Sony RM AV3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Using Non-Preset Remote Control Operations - Learning Function (continued) Notes • If you do not perform learning steps within two minutes, learning mode ends. • If you do not perform Step 6 within 10 seconds after Step 5, the display turns back to the display in Step 4. (All the learnable keys flash.) In this case, perform Step 5 again while the display is flashing, • If you touch a key by mistake in step 6, while pressing the DEL key, press the mistaken key. Then repeat from Step 5 to continue learning. If the Commander does not seem to be working If the learned key or button does not operate properly, teach once again. (For example, if the volume becomes very loud after pressing the VOLUME+ button only once, noise may have interfered during the learning procedure.) If you set a component code after learning a signal If you have programmed any signal for a key or button using the learning function, that signal will remain assigned to that key or button even after you set a component code. When you teach the REC (record) signal If you have to press two buttons at the same time (for example, z and B) to start recording on your cassette deck or VCR, teach the REC signal in one of the following ways. To operate with two keys on the Commander In Step 5 (page 21), while pressing the REC key, press the B key to display both keys. Then press the two buttons on your component's remote control in Step 6. To operate with one key on the Commander In Step 5 (page 21), press only the REC key. Then press the two buttons on your component's remote control in Step 6. When you teach signals to the VOLUME +/ - or MUTING buttons •If you have programmed any signal on the VOLUME +/- or MUTING button for components other than TV and AMP using the learning function, that signal will be transmitted only when you select that component. •If you have programmed any signal for the VOLUME +/- buttons or the MUTING button of TV or AMP using the learning function, that signal will be also transmitted when you select another component. However, if you have programmed any signal for the VOLUME +/- buttons or the MUTING button of another component, that signal will be transmitted only after you select that component. When you teach the signals of an air-conditioner See the notes on page 52. To display only the frequently used keys You can hide keys you do not use. After Step 4 on page 20, while pressing the DEL key, press the key you want to hide (flashing). The pressed key changes to slower flashing and will no longer be displayed during remote control operations. To display it again, perform the same procedure again. Note You cannot hide a key which has "learned" any signal. 22