Sony SNC-DF70N User Guide - Page 38

Administrating the Camera Off: Select if no authentication is required when an eMail is sent. On: When authentication is necessary an e-Mail is sent, select one of the authentication methods from the followings.. SMTP: Select if authentication is required when an e-Mail is sent. POP before SMTP: Select when POP before SMTP is required when an e-Mail is sent. Note When you set to On, make sure to select either or both SMTP or/and POP before SMTP. POP server name It is necessary when the POP before SMTP is selected in Authentication. Type the POP (receiving mail) server name up to 64 characters. Or type the IP address of the POP server. This setting is necessary when the SMTP server which sends e-Mails performs authentication using the POP user account. User name, Password Type the user name and Password of the user who has the mail account. This setting is necessary when the SMTP server which sends e-Mails performs authentication. Recipient e-Mail address Type the recipient e-Mail address up to 64 characters. You can specify only one recipient e-Mail address. Administrator e-Mail address Type the e-Mail address of the camera administrator, up to 64 characters. This is used as the reply address or the address for a system mail from the mail server. Subject Type the subject/title of the e-Mail up to 64 characters. Message Type the text of the e-Mail up to 384 characters. (A line break is equivalent to 2 characters.) You can describe the information of the acquired IP address, etc. using the special tags mentioned below. HTTP notification Select On to output a command to the HTTP server when the DHCP setting is completed. Using this function, you can configure a useful system, for example, to view the access log stored in the HTTP server or start an external CGI program. URL Specify the URL to send HTTP request, using up to 256 characters. The URL is normally written as follows: http://ip_address[:port]/path?parameter ip_address: Type the IP address or host name of the host to which you want to connect. [:port]: Specify the port number to which you want to connect. If you want to use the well-known port number 80, you do not need to input this value. path: Type the command. parameter: Type the command parameter if necessary. You can use the special tags mentioned below for the parameters. Proxy server name When you send HTTP request via a proxy server, type the name or IP address of the proxy server, using up to 64 characters. Proxy port number Specify the port number when you send HTTP request via the proxy server. Set a port number between 1024 and 65535. Method Select the HTTP method GET or POST. OK/Cancel See "Buttons common to every setting menu" on page 27. About the special tags You can use the following five special tags to allow the notification of the settings acquired by the DHCP, such as an IP address. Type the tags in the parameter section of the URL that you described in the Message field of the HTTP. Use this tag to embed the IP address acquired by the DHCP in the text or parameter. Use this tag to embed the specified HTTP server port number in the text or parameters. Use this tag to embed the MAC address of the interface whose IP address you have acquired by the DHCP, in the text or parameter. 38 Configuring the Network - Network setting Menu