Sony SNC-DF70N User Guide - Page 42

Administrating the Camera Authentication Select the authentication required when you send an eMail. Off: Select if no authentication is required when an e- Mail is sent. On: When authentication is required an e-Mail is sent, select one of the authentication methods from the followings. SMTP: Select if authentication is required when an e-Mail is sent. POP before SMTP: Select when POP before SMTP is necessary when an e-Mail is sent. Note When you set to On, make sure to select either or both SMTP or/and POP before SMTP. POP server name It is necessary when the POP before SMTP is selected in Authentication. Type the POP (receiving mail) server name up to 64 characters, or type the IP address of the POP server. This setting is necessary when the SMTP server which sends e-Mails performs authentication using the POP user account. User name, Password Type the user name and Password of the user who has the mail account. This setting is necessary when the SMTP server which sends e-Mails performs authentication. Recipient e-Mail address Type the recipient e-Mail address up to 64 characters. You can specify up to three recipient e-Mail addresses. Administrator e-Mail address Type the Administrator e-Mail address up to 64 characters. This address is used to reply mail and sending system messages from the SMTP server. Subject Type the subject/title of the e-Mail up to 64 characters. When Alarm sending of the alarm tab is set to On, the mail sent due to the alarm detection will indicate the type of alarm in the subject. SI is added for sensor input detection, and MD is added for motion detection. Message Type the text of the e-Mail up to 384 characters. (A line break is equivalent to 2 characters.) OK/Cancel See "Buttons common to every setting menu" on page 27. Alarm sending Tab - Setting the mail sending mode when detecting the alarm Set to send the mail with connection to the alarm detection by the external sensor input or by the built-in motion detection function. Alarm sending Select On to set to send mail with connection to the alarm detection. File attachment Set whether an image file is to be attached to the mail or not. When On is selected, the image file made by the settings below is attached. When Off is selected, only the message is sent. Image file name Type the file name you want to assign to the image to attach a mail. You can use up to 10 alphanumeric, (hyphen) and _ (underscore) for naming. Suffix Select a suffix to add to the file name. None: No suffix is added. The Image file name is assigned to the image to be sent via an e-Mail. Date & time: The date & time suffix is added to the Image file name. The date/time suffix consists of lower two-digits of year (2 digits), month (2 digits), date (2 digits), hour (2 digits), minute (2 digits), second (2 digits), and consecutive number (2 digits), thus 14-digit number is added to the file name. 42 Sending an Image via mail - e-Mail (SMTP) setting Menu