Sony STR-DA5200ES Operating Instructions (Large File - 23.24 MB) - Page 109
Operating without a GUI (Graphical User Interface), To operate on the receiver
View all Sony STR-DA5200ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Operating without a GUI (Graphical User Interface) You can operate this receiver using the display even if you do not use a GUI when a TV monitor is not connected. Press ON SCREEN to switch to "GUI OFF" when "GUI ON" appears on the display. Performing auto calibration For details on the auto calibration, see "9: Calibrating the appropriate settings automatically (AUTO CALIBRATION)" (page 42). Refer to "Before you perform the auto calibration" (page 42) before performing the auto calibration. To operate on the receiver 1 Press ON SCREEN to set the GUI display mode to off. The menu appears on the TV screen when "GUI ON" appears on the display. 2 Press RECEIVER. Receiver operation is enabled. 3 Press MENU. "Auto Calibration" is displayed. 4 Press . 5 Press V/v repeatedly to select a position number to be used, then press . 6 Press V/v repeatedly to select "AUTO CAL START?," then press to start the measurement. Measurement starts in five seconds. A count down appears on the TV screen. Note While the time is counting down, stand away from the measurement area to avoid measurement error. 7 Measurement starts. The measurement process will take approximately 30 seconds. Wait until the measurement process completes. To cancel auto calibration, change the volume, switch INPUT SELECTOR, change the speaker setting of the receiver, connect headphones, turn the muting on, or press ON SCREEN. Note You cannot measure the speaker height of the surround speakers and the surround back speakers. Set this value from "Surround position." settings in the Auto Calibration settings menu (page 72). Tips • Operations other than turning the receiver on or off are deactivated during auto calibration. • In the following situations, the measurements may not be performed correctly or auto calibration cannot be performed. - when special speakers, such as dipole speakers are used. - when the multi zone function is used in zone 2. To confirm/save auto calibration when GUI function is turned off 1 Confirm the measurement result. When the measurement ends, a beep sounds and the measurement result appears on the display. Measurement Display Explanation result When the measurement process completes properly COMPLETE Proceed to step 2. When the measurement process fails ERROR CODE XX See "Message list after auto calibration measurement" (page 46). continued 109GB Other Operations